Woodworking Machinery
..The Equipment Experts

SCM SANDYA 5SCS 1100mm wide belt sander
Roller/pad configuration
* control panel
* powered adjustment of working thickness
* digital readout of working thickness
* natural rubber feed belt
* automatic device for feed belt tracking and tensioning
* floating rubber-coated pressure rollers in the front/rear side of the
operating groups
* infeed flexible steel pressure plate on first operating group
* N.2 infeed support rollers and n.2 outfeed support rollers on the feed belt
* electronic oscillating of sanding belts
* dust extraction outlets with a shape which assures a low air consumption
* "Hand-safety" emergency device in the infeed panel area
* front and rear emergency pushbutton
* padlockable main switch
* automatic star-delta start of the main motor
* overload protection on main motor
* automatic brake for rapid shutdown of operating groups
* automatic emergency stop machine for:
- sanding belt breaking
- not-tensioned sanding belt
- lateral outplacement of sanding belt
- absence of compressed air
- overload on main motors
* motors in isolation class IP54

- working width 1100mm
- min./max. working thickness 4 - 170mm
- sanding belt width 1115mm
- sanding belt length 2150mm
- main motor power 20hp
- feed belt motor power 1.1hp
- feed belt speed 4.5 - 9m/min
* SINGLE COMBINED UNIT "CS" equipped with:
- 'CR/140' roller, 140 mm diameter
- 85 SH rubber coated roller
- manual adjustment of working height
- 'TRP/A' flat stiff pad made of an extractable bar with
felt contact insert density D=0,68
- manual adjustment of working height
- screwed graphite cloth
10.90.87 European safety regulations (CE norms)
Anti-kickback workpieces safety device is included
31.21.60 "RA" Helicoidal grooved steel calibrat. roller-1st group
96.06.71 Electronic positioning for working table. It is equipped with decimal adjustment to pre-set higher or lower workpiece positioning.
The worktable fall and rise is activated by a sensor and a microswitch located near the gauge. On/off selectors allow to disactivate this device in order to carry out the thickness set up by means of fall/rise worktable pushbuttons.